Trail Cage Tubes

Pre-Bent tube and parts for your fabrication projects

PNW4WDA

Blue Ribbon Coalition



	Has your wheelin' increased to a level where you find yourself running the most difficult trails and tougher obstacles? Your stock roll cage is fine for light duty but when you get really serious about wheelin' you need the added protection of our trail cage tubes. We offer several different solutions to help solve shortcommings in the stock Jeep roll cage.
	Rear Spreader bar The rear spreader bar is welded to your stock roll cage bars at the rear of your cage and is intended to prevent the rear bars of your cage from bending inward during a roll over. In the correct position our spreader bar will clear both the hard and soft top and provide maximum head clearance for back seat passengers. Our spreader bars are made using 1.75" ERW tube with .120 wall thickness. Tubes should be trimmed or notched to fit your application. Rear spreaders can also be used at the front if you want more head room over a straight bar. Compare our price to the competitions weld/bolt in spreaders. Price: $55.00
	Side cage bars The factory side bars that run along the top of each door from the center hoop to the windshield must be removed if you want to drop the windshield, leaving you unprotected in a roll over. Our side bars are bent to follow the angle of the windshield and are left long enough to be cut off just above the dash and welded to custom dash brackets that you supply. At the rear you simply slide them over the factory mounts and use the factory hardware or you can weld the mounting flange directly to the bars. If you use a soft top then holes will need to be drilled through the tubes to accomodate the mounting hardware for the factory door surrounds. Tabs also need to be welded at the apex of the bend to tie the bar into the windshield. Price: $70/set of 2
	Universal Spreader Bars Our Universal Spreader Bars are bent on one end at a 45 degree angle and left long so they may be used in a variety of applications. Made from 1.75" x .120 wall ERW tube. Price: $35.00 Straight Spreader Bar (not Pictured) Simply a straight tube used between the front sidebars just above the dash or overhead. Trim/notch to fit. Price: $30.00
	Front Cage support bar for YJ/CJ7 Our Front Cage Support Bar is designed to tie into the factory windshield tube at the top and at the bottom with our MP3175 base plates at the floor. It's bent to match the angle of the windshield and can be mounted in a variety of locations to minimize interference with window cranks, parking brakes, etc. With the addition of one or two of our straight spreader bars and a pair of universal spreader bars one can achieve the look and function of a custom built cage without the major expense normally required. Made from 1.75" x.120" ERW and sold as a pair. Price: $70/pr.
	Rear cage bars for YJ/CJ This is designed for the early YJ and CJ owners who need protection for the family members riding in the back seat. Similar in profile to the TJ rear cage section they are left long to give you the flexibility of choosing the mounting location that best works for you. Add a set of our MP3175 mounting plates and rear spreader bar for additional cross support and you have one stout cage. Made from 1.75"x.120" ERW and sold as a pair. Price: $90/pr.
	Here you can see full use of all our tubes on one cage. Front and rear spreader bars, Universal spreader bars from the center hoop to the front spreader and our side bars. Go to our Product Catalog to order
Click for larger view

JEEP®, WRANGLER™, CHEROKEE™, GRAND CHEROKEE™, CJ™, YJ™, XJ™, TJ™, ZJ™, WJ™ and other names used on this website are registered trademarks or trademarks of DaimlerChrysler or their respective owners.

Front Cage support bar for YJ/CJ7

Rear cage bars for YJ/CJ